1. Introduion

SDI switcher is a high-performance with seamless switching, it can be four input SDI/HD-SDI/3G-SDI serial digital video signal source, after scaling into HD-SDI.3G-SDI serial digital video signal seamless switch to the on HD display device. This produ built-in automatic identification.compatible with SD-SDI, HD-SDI, 3G-SDI all format of SDI signal. It is the support 2.97Gbps bandwidth,.supports lossless transmission over long distances.

2. Features

l 4 SDI input signal switch to 1 SDI sink devices.

l Support seamless switching

l Supports inputs SD-SDI(270Mb/s), HD-SDI(1.485Gb/s), 3G-SDI(2.97Gb/s) video format.

l Built-in cable equilibrium, clock recovery.drive.

l Supports outputs resolutions: [email protected] (3G).[email protected] (HD).

l Supports signal input.output distances of up to 300m for SD signals, 200m for HD signals.100m for 3G signals.

l Supports remote control.on-panel control

l Supports 5-12V wide voltage input.

3. Specifications

l Frequency Bandwidth                  3Gbps

l SDI Input Ports                           4 x BNC Female input port                                         

l SDI Output Ports                         1 x BNC Female output ports

l Power Supply                             DC 5V 1A

l ESD Proteion Human Body Model:    ± 8kV (air-gap discharge)

                         ± 4kV (conta discharge)

l Dimensions (mm)                         70(W) X 145 (D) X 25 (H)

l Weight                                        350g

l Operating Temperature                 0°C ~ 40°C / 32°F ~ 104°F

l Storage Temperature                    -20°C ~ 60°C / -4°F ~ 140°F

l Relative Humidity                        20 ~ 90% RH (Non-condensing)

l Power Consumption (Max)            4W

4. Operation controls.Funions

Front Panel

1)   IR: IR Receiver window (accepts the remote control signal of this device only).

2)   POWER LED: This red LED illuminate when the device is conneed with power supply.

3)   INPUT LED: These inputs status indicating lamp.

(1).Illuminate: SDI input signal stability.

(2).Flashing: Input port is .ed, but there is no input signal.the input signal is not stable

4)   OUTPUT LED: Output rate status indicating lamp.

5)   INPUT .: Press the INPUT button to . an input from the 4 input sources.

6)   RATE .: Press the RATE button will change output rate(3G.HD).

Rear Panel

1)   SDI OUTPUT: This slot is . you conne the SDI displays.monitors with coaxial cable (RG6).

2)    SDI INPUT: These slots are . you conne the SDI source output from SDI Camera.

3)    DC 5V-12V: Plug the 5V.12V DC power supply into the unit.conne the adapter to AC wall outlet.

5. Application Example

更多介紹：www.xinyad.com